Hydraulic manual press head spring
- We use this part for head of hydraulic presses.
- This spring is made of iron with a cover.
- Made for PEX pipe presses.
- Rsco pex pipe press is made of best still alloy.
- Contact us for more information
PEX pipe press types:
- Hydraulic PEX pipe press
- Rechargeable PEX pipe press
- Electrical PEX pipe press
How to set up the PEX pipe manual press PEX pipe w32 industry salvage:
- After removing the manual press from the box, select the jaws from the size of the connection and the corresponding pipe and press on the main jaws.
- After placing the jaws, close the main mandrel screws.
- When the initial point of the jaws collapses, the spacing within the press in the W model is 21-25 cm and in the model A is 31 to 36 cm.
- The permitted distance from the handle is 21-25 cm in the short position and in the 31-36 cm long position.
- The greater the gap between the sections causes the press to break and the less it will cause the seal to fail.
- If the distance between the sections is greater or less, it can be very accurate with the screw head and can be adjusted by rotating about 1.4 turns.
- the adjustment knob (12) is locked, the screw (13) can be opened in three rounds and the set will be released after opening the screw.
- After locking the screw, adjust the screw (13) to its original state and restart it.
Rastegar repairs the following products:
- Repair of polyethylene welding machine.
- Repair of polyethylene welding iron.
- Green Green Foam Repair.
- pex pipe press repair.
- Repair of pex pipe-loaded press.
- Five-layer tube press repair.
- Hydraulic press repair of pex pipe.
- pex manual press repair.
- Repair the welding machine inverter.
- Repair leak detectors.
- Repair for plumbing test devices.
Read moreShow less